Mounting Instruction
Conductor rail system
MultiLine 0835
MAL0835-0001c-EN
www.conductix.com
translated document
page 15 of 81
Required protective equipment:
DANGER!
Risk of injury from cuts and cutting!
The ends of the power rails can have sharp edges, especially if they were cut to size at the
construction site and have not been deburred.
→
Wear protective gloves and protective footwear.
→
During installation: Carefully deburr the insulation profile and the power rail after they have been cut
to size
→
During disassembly: Cut, dismantled conductor rails must be handled carefully and properly stored
(container or transport box)
→
Look out for sharp edges near the installation surface and avoid contact.
Required protective equipment:
DANGER!
Risk of injury from falling power rails when transported incorrectly!
When being transported on the construction site, there is a risk that the power rails may slide out of the
insulation profiles if they are not held roughly vertical during transport. This can cause serious injury and
even death if they fall from a great height and hit somebody with their front end.
→
The conductor rails should be transported as close as possible to the site of installation inside
their packaging.
→
The conductor rails must be carried to the installation site by two people and care must be taken
that the power rails do not slide out of the insulation profiles
→
Do not transport the conductor rails in bundles with a crane
→
Wear protective headgear
Required protective equipment:
DANGER!
Risk of injury due to entrapment!
There is a risk of being trapped by moving parts when the system is in operation. Moving parts
include, e.g. the shuttle and the current connector fitted to it.
→
Do not enter the system's danger zone during operation
→
Always
disconnect the conductor rail system from the power supply
according to the 5 safety
rules and
secure it against being switched back
on before working on it. For the 5 safety rules,
see section 2.6
→
Wear close fitting working clothes
