Comtech EF Data SDM-2020, Installation And Operation Manual

Page: 183 / 215

Remote Control Operation SDM-2020 Satellite Demodulator
B–8 Rev. 3
B.5 System Configuration Commands/Responses
Time Of
Day Command:
Response:
Status:
Response:
<add/TIME_hh:mmxx'cr'
>add/TIME_hh:mmxx'cr''lf']
<add/TIME_'cr'
>add/TIME_hh:mmxx'cr''lf']
Where:
hh = 1 to 12 (hours).
mm = 00 to 59 (minutes).
xx = AM or PM.
Date Command:
Response:
Status:
Response:
<add/DATE_mm/dd/yyyy'cr'
>add/DATE_mm/dd/yyyy'cr''lf']
<add/DATE_'cr'
>add/DATE_mm/dd/yyyy'cr''lf']
Where:
mm = 1 to 12 (month).
dd = 1 to 31 (day).
yyyy = 00 to 99 (year) in 2-digit year mode and 1975 to
1999 and 2000 to 2075 in 4-digit year mode.
Remote
Configures
the MODEM
for Remote
Operation Command:
Response: <add/REM_'cr'
>add/REM_'cr''lf'] The demodulator will respond to any status request at any
time. However, the demodulator must be in 'Remote Mode' to
change configuration parameters.
Clear
Stored
Faults Command:
Response: <add/CLSF_'cr'
>add/CLSF_'cr''lf'] This command is used to clear all stored faults logged by the
demodulator.
Save
Modem
Config. Command:
Response: <add/SMC_nn'cr'
>add/SMC_nn'cr''lf'] Where: n = 1, 2, 3, ..., 10 (stored configuration number).
This command saves the current demodulator configuration for
recall at a later time using the 'RMC_' command. Up to ten
different demodulator configurations can be saved.
Recall
Modem
Config. Command:
Response: <add/RMC_nn'cr'
>add/RMC_nn'cr''lf'] Where: n = 1, 2, 3, ..., 10 (stored configuration number).
This command causes the demodulator to be reprogrammed
with configuration parameters previously saved using the
'SMC_' command. One of ten saved configurations can be
specified.