Compaq Deskpro AP240, Reference Manual

Page: 53 / 216

Reference Guide 2-19
Writer: Your Name Saved By: Lydia Sanchez Saved Date: 07/30/99 12:34 PM
Pages: 20 Words: 3935 Template: c:\word7\templates\comm.dot
File Name d-ch2.doc Part Number 158415-001
3. Select Custom Test.
A choice of two test modes is offered: Interactive Mode
and Unattended Mode.
4. Select Interactive Test
→
Storage
→
Hard Drives.
5. Select the specific drive(s) to be tested
→
Drive Protection
System Test
→
Begin Testing.
When the test has been completed, one of three messages will
be displayed for each of the drives tested:
■ Test Succeeded. Completion Code 0.
■
Test Aborted. Completion Code 1 or 2.
■ Test Failed. Drive Replacement Recommended. Completion
Code 3 through 14.
If the test failed, the completion code should be recorded and
reported to your service provider for help in diagnosing the
workstation problem.
Accessing DPS
Through Computer
Setup
When the workstation does not power-on properly you should
use Computer Setup (F10 Setup) to access the DPS program
(Intel 820 chipset only). To access DPS, perform the following
steps:
1. Turn on or restart the workstation.
2. When the F10 Setup message appears in the lower-right
corner of the screen, press the F10 key.
✎
If you do not press the F10 key while the message is
displayed, you must turn the workstation off, then on
again, to access the utility.
A choice of five headings appears in the Computer Setup
Utilities menu: File, Storage, Security, Power, and Advanced.