10-4
Expansion Boards
Writer: Erica T Blakeney Project: Compaq Professional Workstation 5100 Reference Guide Comments: 299348-003
File Name: K-CH10.DOC Last Saved On: 3/12/98 12:16 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Installing an Expansion Slot Cover
To install an expansion slot cover:
1. Slide the expansion slot cover into place over the slot opening.
2. Install the screw at the side of the expansion slot to secure the slot cover.
Installing a PCI or ISA Board
NOTE
: These procedures can also be used for installing a graphics
controller. For more information on graphics controllers, see Chapter 11.
To install a PCI or ISA expansion board:
1. Remove the expansion board cage from the workstation chassis.
2. Remove the expansion slot cover.
3. Slide the expansion board into the expansion slot and press it firmly into
place.
NOTE
: When installing an expansion board, make sure you press firmly on
the board so that the whole connector seats properly in the expansion board
slot. If you are installing a full length expansion board, be sure to engage the
card guide located behind the fan bracket (not shown).
Figure 10-3. Installing an expansion board
