Comet MTP AX Misting, Assembly, Operation And Maintenance Instructions, Page: 35 / 104

35
WARNING
• Once the motor pump and the machine in which it is integrated have cooled down, be careful:
- not to leave them unattended in the presence of children, elderly people or disabled persons without supervision;
- to arrange them in a stable position without any risk of falling;
- not to put them in contact or in the immediate vicinity of inflammable materials.
CLEANING AND DECOMMISSIONING
WARNING
• WARNING. All cleaning jobs must only be performed after carrying out the operations described in the
“s
top
” paragraph, meaning without any moving parts, no pipe full of liquid under pressure and only
after complete cooling.
In particular, always remember to disconnect the power supply.
• Any cleaning jobs must be performed in conditions of total stability.
• To clean, do not use thinners or solvents.
CAUTION
•
The motor pump must be protected against freezing.
In very cold environments, to prevent the ice from forming inside, before decommissioning, it is best to
suction a car anti-freeze product (after contacting a Skilled Technician inasmuch as the liquid could damage
the high-pressure pump seals) and then proceed to fully expel it. If it is not possible to protect the motor
pump this way, before starting it, take it to a warm environment for long enough to melt any ice inside.
Failure to do so could cause serious damage to the motor pump.
WARNING
• The antifreeze liquid must be suitably disposed of and not discarded in the environment.
NOTE .
After a prolonged stop, slight water dripping could occur underneath the motor pump. Such dripping normally
disappears after a few hours of operation. Should it persist, contact a Skilled Technician .
MAINTENANCE
WARNING
• Follow the maintenance instructions contained in the manual of the machine in which the motor pump
is integrated.
• All maintenance jobs must only be performed after carrying out the operations described in the “s
top
”
paragraph, meaning
without any moving parts, no pipe full of liquid under pressure and only after
complete cooling.
In particular, always remember to disconnect the power supply.
• Any maintenance jobs must be performed in conditions of total stability.
•
WARNING.
To ensure the safety of the motor pump, only use original spare parts supplied by the Manufacturer
or approved by it.
EN