52
ie-ms2-MS6-10
9.3.11
Mechanical parameters
Dimensions of the
MS6D case:
215 x 165 x 44 mm without connectors and without mounting
consoles
215 x 225 x 44 mm with connectors and without mounting consoles
Dimensions of the
MS6R case:
165 x 230 x 44 mm without connectors and without mounting
consoles
225 x 230 x 44 mm with connectors
483 x 230 x 44 mm with mounting consoles to rack 19’’
Dimensions of the
MS6-Rack case:
483 x 190 x 44 mm without connectors
Weight:
approximately 800 g
Protection:
IP20
Input terminals:
removable, maximum cross section of lead: 1.5 mm
2
Mounting:
desk top
–
standard version (MS6D or MS6R)
by means of two mounting consoles
–
optional accessory for MS6D
by means of DIN rail 35 mm holder
–
optional accessory for MS6D
by means 19’’ rack mounting consoles –
MS6R
9.4
Technical parameters of inputs
Every input channel can be set by means of user SW for measurement of different electrical values. It
requires correct wiring of input terminals. Analog inputs are not mutually galvanically isolated. For the
need to recalculate measured values menu item Recalculations in user program is designed to configure data
logger. Here it is possible to assign measured values required values by means of two-point linear
transformation. Then accuracy specification must be recalculated in corresponding way.
9.4.1
Absolute limit values
Exceeding of those values can cause damage of data logger or undesired influence to
its behavior.
9.4.2
Recommended operating conditions
terminal limit values
+Up
short circuit against IN, COM and GND is possible
no external negative voltage against GND terminal
can be connected
IN
±24 V
DC against COM or GND
COM
±6V or ±50mA against GND
GND