ie-ms2-MS6-10
13
3.2.
Data logger interface connectors
Connectors
Each signal is connected to self-locking terminal WAGO located on the side of the case. Insert flat-
bladed screwdriver to rectangle terminal hole and push screwdriver towards away from you - contact is
released. Connect wire to released terminal (circular hole behind the rectangular one) and close the terminal
by removing the screwdriver.
Notice: The entire input terminal block is possible to remove from data logger by pulling it up from the
connector.
Connection of leads:
Terminals of input channels are keyed to prevent undesirable mismatch between channels.