41IOM004 – Module with 4 relay outputs with isolator
17/06/2020 14:06
41IOM004
Address
Loop Number
Device Zone
3
2
1
Enabled
New
Device State
More
Remove
OFF
Name
Save
17/06/2020 14:06
0
ON
Sounder Group
Led Blink
Software Revision
ID
2.0
3195011485
The figure shows the settings screen for module 41IOM004.
This module can be used to control its 4 built-in relay outputs.
For further technical information and module and output wiring, please refer to the technical manual for this device.
Press “MORE” to access additional settings:
• LED Blink: select ON/OFF to enable/disable LED indications for the device.
If ON, the LED flashes at every panel dialogue cycle; if OFF, the LED does not flash during the dialogue cycle.
A name of up to 40 characters can be assigned to each output channel in the editable bar next to the “Name” label”.
The configurable “rapid programming” options on the 4 outputs of module 41IOM004 are the same as those listed in
the paragraph concerning addressed module 41IOM022 (output channels).
To save any new parameters, press “Save” on the main device screen.
41
