coldline W30, Use And Maintenance Manual

Page: 39 / 196

39
Р
ус
ск
и
й
E
e
sp
a
ñ
o
l
N
e
d
e
rl
a
n
d
s
It
al
ia
no
E
ng
lis
h
D
eu
ts
ch
Fr
an
ça
is
Make sure that there is sufficient space to prevent the tube from being crushed or obstructed.
Make sure that after being connected the pipe does not go up and then back down, to avoid the formation
of a siphon that might prevent correct water flow.
3.10 FASTENING
Ensure that the bottom of the unit can support a weight of 70 kg.
Place the appliance in the compartment and secure in position with the screws supplied.
3.11 PUTTING INTO OPERATION
Before connecting the appliance to the power mains, make sure that:
voltage and frequency comply with the working conditions indicated on the plate: the maximum tolerance
is ± 10% of the rated value.
the power supply circuit meets current regulations;
the electric system is fitted with a residual current circuit breaker (automatic cut-out);
the air intakes provide a sufficient level of ventilation;
the ambient temperature of the area of installation does not exceed 32°C. Beyond this temperature, the
stated performance levels are not guaranteed;
The drain plug is in the correct position (see the figure), both with the appliance off and during operation.
This is to prevent foreign objects from obstructing the drain.
If the appliance has been transported in a non-vertical position, wait at least 4 hours before switching it
on. During positioning, do not tilt the appliance to an angle exceeding 30°.