Keypad and display menus
98-165591-B
Chapter 4: Setup and operation
4-23
4444
Top-level menu
Menu descriptions
Top-level menu
Description
MAIN
View with current status of the VSAT system.
The status screen is displayed again after a time out of 10 minutes.
New events are shown in this display. If an event is displayed, press
OK
to jump directly to
EVENTS
for viewing the currently active
events. Press any key (except left arrow) to go to
MAIN
.
OPERATION
Allows you to deploy, stow or stop the antenna.
MANUAL POINTING Allows you to enable or disable manual pointing
PROFILE
Allows you to select which satellite profile to use.
ANTENNA
Shows the current antenna parameters, position, polarization,
software version and serial numbers of the antenna and Base Unit.
MODEM
Modem information, including modem type and status for TX
enable and Rx Lock. Also status for the modem LEDs.
NETWORK
Shows the IP addresses and netmasks of the local IP ports on the
Base Unit, and the default gateway.
SATELLITE
Current satellite information. This information is configured using
the web interface.
EVENTS
View system events. Number of active events are shown as: X
ACTIVE EVENTS in the
MAIN
display. Press
OK
to see the list.
See Appendix B,
, for a list of event messages
that may appear in the display and the web interface.
OPERATION
Description
DEPLOY
Press
OK
to deploy the antenna
STOW
Press
OK
to stow the antenna
STOP
Press
OK
to stop the antenna immediately.
The status shows STOPPED
START
Press
OK
to start the antenna when it has been stopped.
The antenna will automatically deploy.
MANUAL POINTING
Description
AZI ELE SIG
Current values for azimuth, elevation, signal strength indicator
ENABLE/DISABLE
Current status: enabled or disabled
