List of events
98-165591-B
Appendix B: System messages
B-10
BBBB
0A03B-0 ERROR
Azi DDM
shutdown
The azimuth motor control has detected one of the following
situations: Extreme temperature, voltage, current or velocity.
The motor was then shut down. This is usually a temporary
situation and is probably fixed by a restart of the system.
0A03C-0 ERROR
Xel DDM
shutdown
As Azi DDM/DMD/FDM shutdown but detected by the cross-
elevation motor control.
0A03D-0 ERROR
Ele DDM
shutdown
As Azi DDM/DMD/FDM shutdown but detected by the
elevation motor control.
0A03E-0 ERROR
PMM shutdown As Azi DDM/DMD/FDM shutdown but detected by the
polarisation motor control.
0A03F-0 WARNING AMB timing
This indicates a busy situation. It may occur during
installation procedures. No user interaction is required unless
it occurs repeatedly.
0A040-0 WARNING VIM cable attn
The output power cannot be controlled correctly. Check the
Tx chain.
0A043-0 WARNING LNB voltage low The voltage for the LNB is too low probably caused by a
malfunctioning VIM or LNB.
0A044-0 WARNING LNB voltage
high
The voltage for the LNB is too high probably caused by a
malfunctioning VIM.
0A047-0 ERROR
VIM PLL lock
The PLL of the VIM is out of lock. Check the 10 MHz
reference signal.
0A048-0 WARNING VIM tuner lock
The PLL of the second receiver (DVB) is out of lock. Check the
10 MHz reference signal.
0A049-0 WARNING Azi encoder slip A slip of the azimuth encoder has been detected. If this
event is not resolved by itself after some time, check the belt
and encoder of the azimuth axis.
0A04A-0 WARNING Xel encoder slip A slip of the cross-elevation encoder has been detected. If
this event is not resolved by itself after some time, check the
belt and encoder of the cross-elevation axis.
0A04B-0 WARNING Ele encoder slip A slip of the elevation encoder has been detected. If this
event is not resolved by itself after some time, check the belt
and encoder of the elevation axis.
0A04D-0 WARNING GNSS position
No position available from the GNSS device or position too
old.
0A04E-0 WARNING GNSS velocity
No velocity available from the GNSS device.
0A04F-0 WARNING Heading data
Heading information is missing in the antenna.
Event ID
Severity
Description
Explanation
