34
DECrepeater 90TS Installation and Configuration
Configuring the Module
Table 1
DLU Process Description
Stage
What Happens
1
The new firmware image from the TFTP load host is trans-
ported across the network, and placed into a temporary stor-
age buffer in the module.
Indications that this stage is in progress include:
•
Module status — functional, but not manageable.
•
Module cannot respond to management requests.
•
LED display — The Power
, Module OK , and Network* LEDs
remain on. The Port State LED #2 lights.
•
HUB Manager display —
DECrepeater 90TS
unknown
•
Typical time to complete this stage — normally 1 minute, however,
due to variances in network configurations (load path, bit rate, and
traffic levels), this stage of the DLU process can take up to 10
minutes to complete.
(continued on next page)
*If the module is connected to the network through the ThinWire port, the
Network OK # A LED is lit. Otherwise, if the module is connected to the
network through the AUI port, the Network OK # B is lit.
