46
DECrepeater 90TS Installation and Configuration
Configuring the Module (Cont.)
After selecting the option to switch to OBM mode, do the following:
1. Change the cable at either the front-panel serial port on the module or at the
OBM device using one of the cable/adapter pairs listed in the table below.
a. If the OBM device uses the same cable as the setup port device, discon-
nect the cable from the setup port device, and install it into the OBM device
(see illustration).
b. If the OBM device uses a different cable than that used for the the setup
port device, disconnect the cable from the front-panel serial port of the
module, and connect the cable from the OBM device into the front-panel
serial port of the module (see illustration on the next page).
Cable/Adapter Type
Connecting OBM Device
BN25G-xx
1
/H8585-AC
2
A modem with a 25-pin D-Sub connector
BN25G-xx
1
/8585-AA
A PC with a 9-pin D-Sub communications port
BN24H-xx
1
/8584-AA
An 8-pin MJ terminal server
1
xx indicates cable length in meters.
2
Not for connection to public networks in Sweden, Germany, or Japan.
