Choose option 13, then
go to the section titled
Start Redirect Mode.
The DECrepeater 90TS does not
support
Option [9] Downline
Upgrade
from this menu.
You must choose
Option [13]
Start Redirect Mode
to perform
a downline upgrade to this module.
DECrepeater 90TS Installation and Configuration
19
Configuring the Module (Cont.)
3. Press
Return
on the setup port device a few times until a menu appears.
a. If the setup port device is connected to the module’s front-panel serial
port, the
DECrepeater 90TS INSTALLATION MENU
appears. Go to
the section titled DECrepeater 90TS Installation Menu
(DEChub90/Standalone Options), on page 21.
b. If the setup port device is connected to the Hub Manager setup port on the
DEChub 900, the
DEChub 900 MultiSwitch INSTALLATION
MENU
appears (see following example).
The following is an example of the
DEChub 900 MultiSwitch INSTALLATION
MENU
:
DEChub 900 MultiSwitch
DEChub 900 MultiSwitch INSTALLATION MENU
[1] Reset with Factory Defaults
[2] Reset with Current Settings
[3] Show Current Settings
[4] Set SNMP Read/Write Community
[5] Add SNMP Trap Addresses
[6] Delete SNMP Trap Addresses
[7] Dump Error Log
[8] Set In-Band Interface IP Address
[9] Downline Upgrade
[10] Set Out-of-Band Interface IP Address
[11] Set Out-of-Band Interface Port Speed
[12] Start Event Display Mode
[13] Start Redirect Mode
Enter selection : 13
Return
c.
Go to the section titled Start Redirect Mode, on the following page.
