DECrepeater 90TS Installation and Configuration
23
Configuring the Module (Cont.)
Description of Menu Options
This section describes the menu options that are available from the
DECrepeater
90TS INSTALLATION MENU
. Note that the out-of-band management options
apply to the module only when it is installed into a DEChub 90 or it is in standalone
mode.
[1] Reset with Factory Defaults
This option resets the module, causing most of the module’s configured NVRAM
parameters to be initialized to factory default values.
Following are examples of the module’s configured NVRAM parameters that are
reset to factory defaults:
•
SNMP read/write community name –– this name is reset to
PUBLIC.
•
SNMP trap addresses ––all SNMP trap addresses are deleted.
•
In-band interface IP address –– this address is deleted.
•
In-band interface default gateway address –– this address is deleted.
•
Out-of-band interface IP address –– this address is deleted.
•
Out-of-band interface port speed –– reset to 9600.
Following are the only parameters that are not reset:
•
Serial number
•
Reset count
•
Error log data
