All content © 2020, cmotion GmbH. All specifications are subject to change without further notice.
http://www.cmotion.eu
page 78 of 120
Each motor menu consists of:
Axis (status)
Direction (status)
Ramp (status)
Torque (status)
Calibrate
Manual calibration
6.2.3.4.2.1. Axis
The axis menu allows you to change the motor assigment to Focus, Iris, Zoom or Aux.
Note: The axis menu changes the motor assignment not the assignemnt of the control
interface. With cforce motors you can change the motor assignment on the motor itself by
pressing the FIZ button. In order to change the motor assignement for a cPRO motor, please
refer to the cPRO motor user guide.
NOTICE
“Aux” stands for auxiliary and allows you to assign any cforce motor connected within the
cPRO network for auxiliary / 4th axis control. Aux can only be assigned to a cforce motor
through the cPRO hand unit. This is not possible through the FIZ selection button on the back
of each motor. Once assigned to Aux, the motor will remain Aux, even when power-cycled.
However, the motor axis can be reassigned through the cPRO hand unit again. Pressing the
FIZ button on the cforce motor will disable the Aux setting and only allow you to select Focus
Iris or Zoom.
6.2.3.4.2.2. Torque
The torque menu allows you to adjust the strength of the motor to min, weak, strong and
max.
Note: Increasing the motor torque drains more power from the system and can place stress
on the lens. Only increase the torque as much as necessary to achieve reactive and fluent
lens control.
6.2.3.4.2.3. Direction
The direction menu allows you to set the side of the camera which the lens motor is
mounted to either left or right.
Note: The direction is defined from the operators point of view, from behind the camera.