ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Adjustment
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 5-5
5
4. ADJUST ACCELERATOR PEDAL HEIGHT
4.1. Loosen the nut and bolt
securing the accelerator pedal to the pivot plate.
Clamp the accelerator pedal adjustment tool (Club Car Part No. 1018710-01) to the accelerator
pedal, with the end marked
accelerator pedal height
closest to the floorboard, next depress the
accelerator pedal until the end of the tool rests against the floorboard (pedal height should be 5-5/
8 inches (14.3 cm). Use a rubber strap to hold pedal in position against the floorboard and then
tighten nut to 26 ft-lb (35.3 N·m)
5. ADJUST THE ACCELERATOR ROD
• For gasoline vehicles, proceed to step 5, Adjust Accelerator Rod – Gasoline Vehicles.
• For electric Turf 1 and Carryall 1 vehicles, proceed to step 5, Adjust Accelerator Rod –
Turf 1 and Carryall 1 Electric Vehicle Only.
• For electric Turf 2, Carryall 2 and 6 vehicles, proceed to step 6, Adjust The Actuator Lever.
Figure 5-8 Brake Rod Adjustment
Figure 5-9 Accelerator Pedal Height Adjustment
Figure 5-10 Accelerator Pedal Height Adjustment
• BEFORE SERVICING, TURN THE KEY SWITCH TO
OFF
AND PLACE THE FORWARD/
REVERSE HANDLE IN THE NEUTRAL POSITION.
DANGER CONTINUED ON NEXT PAGE...
ROTATE BALL JOINT (11)
CLOCKWISE TO INCREASE PAWL
TO RACHET ENGAGEMENT,
COUNTERCLOCKWISE TO DECREASE IT.
SNAP LOOSE BALL JOINT (11) FROM
BEHIND PARK BRAKE PEDAL
11
1/2 INCH SOCKET
1/2 INCH WRENCH
PARK
GO
ACCELERATOR
PEDAL HEIGHT
STOP
PARK
STOP
GO
ACCELERATOR
PEDAL HEIGHT
ACCELERATOR PEDAL
ADJUSTMENT TOOL (CLUB
CAR PART NO. 101871001)
USE AS SHOWN
USE A RUBBER STRAP
TO HOLD PEDAL IN
DEPRESSED POSITION
DANGER
