Club Car CARRYALL 1 2000, Maintenance And Service Manual

Page: 127 / 136

REAR SUSPENSION Snubber
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 9-7
9
SNUBBER
Read WARNING on Page 9-1.
The snubber is installed on the gasoline vehicle only.
SNUBBER REMOVAL
1. Support the drive train with a floor jack under the engine mounting plate so that the snubber is raised
slightly and does not rest on the vehicle frame.
2. Remove the two bolts (2) and two locknuts (1) securing the snubber bracket to the engine mounting
plate (Figure 9-5, Page 9-7) .
3. Slide snubber and bracket assembly toward battery to remove it from vehicle.
SNUBBER INSTALLATION
1. Install in the reverse order of removal.
2. Tighten snubber bracket mounting nuts (1) to 13 ft-lb (17.6 N·m) (Figure 9-5, Page 9-7) .
3. Tighten snubber bracket mounting nuts (1) to 13 ft-lb (17.6 N·m) (Figure 9-5, Page 9-7) .
STABILIZER BAR
Read WARNING on page 9-1.
A stabilizer bar is installed on gasoline Turf 2, Turf 6, Carryall 2, Carryall 2 Plus and Carryall 6 vehicles.
STABILIZER BAR REMOVAL
1. Place chocks at the front wheels and lift the rear of the vehicle with a chain hoist or floor jack. Position
jack stands under the frame cross-member between the spring mount and the side stringer, just for-
ward of each rear wheel. Lower vehicle to let the jack stands support the vehicle.
2. Remove bolt (6), lock washer (7), flat washers (4), compression mounts (3) and spacer (2) from left and
right stabilizer bar links (5). Do not remove the stabilizer bar links from frame (Figure 9-6, Page 9-8).
Figure 9-5 Snubber Brackets
SNUBBER MOUNTING
BRACKET
Club Car
SNUBBER
2
1