Modules
7 - 2 Setting Up SATA RAID Mode
7
Setting Up SATA RAID Mode
AHCI Mode
Advanced Host Controller Interface (AHCI) is an interface specification that allows
the storage driver to enable advanced serial ATA features such as Native Command
Queuing (for maximum hard disk efficiency and performance). AHCI mode can be
supported by one, two or three hard disks.
RAID
To configure your system in Striping (RAID 0) or Mirroring (RAID 1) modes (see
Table 7 - 1, on page 7 - 3
) you will require
at least
two
identical
(see sidebar) hard
disks; to configure your system in Intel
®
Rapid Recover Technology (Recovery)
mode you will require
two hard disks
installed; to configure your system in Parity
Across Disks (RAID 5) mode you will require
three hard disks
installed.
Intel
®
Matrix Storage Manager
Make sure you install the Intel Matrix driver and application if you have set up your
hard disk(s) in
RAID
mode (see
“Intel Turbo Memory & Matrix Storage Setup and
Driver Installation” on page 7 - 8
).
RAID Hard Disks
All hard disks in a RAID
should be identical (the
same size and brand) in
order to prevent unex-
pected system behavior.
Summary of Contents for X7200
