Clack Water Specialist EI, Programming And Cover Drawing Manual

Page: 6 / 24

Page 6 EI Man u al
User 1
Typical user display. Shows volume remaining to regeneration. This screen will not
be viewed if the control is set for time-clock operation.
User 2
Displays number of days to next regeneration. Only viewed if Step 11S or Step 5F is
set to OFF.
User 4
Displays total volume in cubic meters since last reset. If a meter is not used this
display will be shown but 0 will be displayed.
PRESS
▼
FOR 3 SECONDS TO RESET TO 0.
User 5
Shows current time.
Setting Time of Day
Push NEXT until time of day screen is displayed. Press and hold
▼
until SET
TIME is displayed and the hour fl ashes once. Press
▲
or
▼
until the correct hour is
displayed.
Then press NEXT. The minutes will fl ash. Press
▲
or
▼
until the correct minute is
displayed.
Press NEXT to return to the User Displays. Time of day should only need to be set
after power outages lasting more than 8 hours, if the battery has been depleted and
a power outage occurs, or when daylight saving time begins or ends. If a power
outage lasting more than 8 hours occurs, the time of day will
fl ash on and off which
indicates the time of day should be reset. If a power outage lasts less than 8 hours
and the time of day
fl ashes on and off, the time of day should be reset and the battery
replaced.
User Displays
General Operation
When the system is operating, one of fi ve displays may be shown. Pressing NEXT
will alternate between the displays shown below.
User 3
Displays fl ow rate L/min. If a meter is not used this display will be shown but 0 will
be displayed. If 1.0 is selected in Step 2CS an “A” in front of the fl ow rate indicates
that the tank with the control valve on it is in service. If “b” is displayed the tank
with the in/out head is in service.