6- 24
6-2-1-4 Self Sample Hold (Static Width)
Parameter name
Setting value
Remarks
Measurement mode (MEAS)
Selects a hold mode.
S-H (Sample hold)
P-H / B-H / P-P / P-P/2
NG-H (NG hold)
SLF.S-H (Self sample hold)
SLF.P-H (Self peak hold)
SLF.B-H (Self bottom hold)
[Default: S-H]
Self trigger level
(SLF.LV)
Sets the reference level for the hold function using the self
(internal) trigger.
−199.9999 to 199.9999
[Default: 0.500]
Self trigger edge direction
(SLF.EDG)
Sets the edge direction for measurement of the hold value using
the self trigger level.
UP (Rise) / DOWN (Fall)
[Default: UP]
Self trigger delay
(SLF.DLY)
Sets the self trigger delay type and its reference value when the
self sample hold function is used.
DLY.WD (Static width) /
DLY.TIM (Delay timer)
[Default: DLY.WD]
Static width (DLY.WD)
0 to 199.9999 (mm)
[Default: 0.0100]
After exceeding or falling below the specified self trigger level (depending on the specified self trigger edge
direction), the judgment value is held automatically when the normal measurement value becomes stable
within the specified static width.
Fulfillment of the above condition activates self triggering, which updates the judgment value. Until that time,
the output continues to be held.
Self trigger level and self trigger
edge direction
It is recommended that the self trigger direction be set
to UP when the self trigger level is lower than the
LOW setting value, as shown in the figure above, and
that it be set to DOWN when the self trigger level is
higher than the HIGH setting value, as shown in the
figure on the right.
（ 無効）
（消灯）
（消灯）
HOLD
TRIG
TRIG
all off
Hi
Lo
Go
T
all off
all off H+L
all off
TRIG
HIGH setting value
LOW setting value
TRIG
TRIG display
HOLD display
Judgment output
Self trigger level
(Light
OFF)
(No effect)
（ 無効）
（消灯）
（消灯）
HOLD
TRIG
TRIG
all off
Hi
Lo
Go
T
all off
all off H+L
all off
TRIG
HIGH setting value
LOW setting value
TRIG
TRIG display
HOLD display
Judgment output
Self trigger level
(Light
OFF)
(No effect)
