Cisco TES301, User Manual

Page: 76 / 138

Chapter 4 Configuring Advanced Settings
58 4038767 Rev B
IPv6 Setup
Field Description
IPv6 WAN
Listen to Router
Advertisement Select Enabled (default) to allow the WAN interface to accept
router advertisements. Otherwise, select Disabled .
Static Configuration
Select Enabled to activate the fields for this option. Otherwise,
select Disabled (default).
Choose from the following options:

WAN address/prefix_length —Specify wan side IPv6
address with length of the prefix used for network part. The
format must be as follows:
xxxx:xxxx:xxxx::xxxx/num

WAN Default router —Specify wan side IPv6 router address
the packet will be sent.

LAN address/prefix_length —Specify lan side IPv6 address
with length of the prefix used for network part.
DHCPv6 Client
Choose from the following options:

Disabled —No DHCPv6 running on WAN interface. User
will get IPv6 address either through stateless auto config or
static config.

PD Enabled —DHCPv6 will run on WAN interface to get
prefix delegation information which will be used to decide
lan side IPv6 address.

IA Enabled —DHCPv6 will run on WAN interface to get
identity aggregation info from DHCPv6 server to use it to
decide WAN interface IPv6 address.

IA+PD Enabled —DHCPv6 will run on WAN interface to
get both identity aggregation and prefix delegation
information.

Stateless —DHCPv6 client will auto-configure IP address
based on router advertisements or manual configuration
instead of requesting IP address from DHCP server.
DHCPv6 Client under this mode will only send
Information-request message for configuration parameters
from DHCPv6 server.
DUID
WAN-interfacing device unique identifier. If you choose to
change it, the format must be as follows:
00:03:00:01:xx:xx:xx:xx:xx:xx