Cisco TES301, User Manual

Page: 77 / 138

Setup
4038767 Rev B 59
Field Description
Show DHCPv6 Config
1
Click this button to display information for the DHCPv6
Client Configuration.
2
Choose a tab to view the DHCPv6 related details.
3
Click Close to return to the previous view.
IPv6 Route Configuration
1
To set up an IPv6 route, select a number from the Select set
number drop-down list.
2
Enter the following data:
– Destination —The Destination IP Address is the address
of the network or host to which you want to assign an
IPv6 route.
– Prefix Length —The length of the prefix provided by
your service provider.
– Interface —Depending on where the Destination IP
Address is located, select LAN & Wi-Fi or WAN
(internet) from the drop-down menu.
3
To save your changes, click the Save Changes button. To
cancel your unsaved changes, click the Cancel button. For
additional IPv6 routes, repeat steps 1-3.
IPv6 WAN Tunneling
6rd Tunnel
Select Enabled to activate the fields for the 6rd Tunnel setup.
Otherwise, select Disabled (default). If enabled, configure the
following options:

6rd Prefix —The IPv6 prefix provided by your service
provider and used as the leading part of the IPv6 address
when tunneling IPv4 through IPv6.

6rd Prefix length —The length of the IPv6 prefix provided
by your service provider.

IPv4 Mask Length —The length of the mask portion of the
IPv4 address.

Relay —The IPv4 address of the relay router.
6to4 Tunnel

Enabled —If the WAN IPv4 address is configured for NAT,
select Enabled to configure the WAN port to use the well
known 2002::IPv6 prefix.

Disabled —Select Disabled if you do not want to use the
6to4 Tunnel feature.
IPV6 LAN
Send Router Advertisement

Select Enabled to allow the router to send router
advertisement to the LAN-interfacing host.

Select Disabled if you want the LAN-interfacing host
connected to this router to not have a global IPv6 address.