Cisco TES301, User Manual

Page: 72 / 138

Chapter 4 Configuring Advanced Settings
54 4038767 Rev B
MAC Address Clone
MAC Cloning
The gateway's MAC address is a 12-hexadecimal digit code assigned to a unique
piece of hardware for identification. Your service provider may require that you
register the MAC address of your network card/adapter, which was connected to
your cable or DSL modem during installation. If so, find your adapter's MAC
address by following the instructions for your PC's operating system.
For Windows 98 and Millennium:
1 Click the Start button; then, select Run .
2 Type
winipcfg
in the field provided, and press the OK key.
3 Select the Ethernet adapter you are using.
4 Click More Info .
5 Write down your adapter's MAC address:
______________________________________
For Windows 2000 and XP:
1 Click the Start button; then, select Run .
2 Type
cmd
in the field provided, and press OK .
3 At the command prompt, type
ipconfig /all
and press Enter to determine
your adapter's physical address.
4 Write down your adapter's MAC address:
______________________________________
Clone your network adapter's MAC address onto the gateway:
1 Select Enable .
2 Enter your adapter's MAC address in the MAC Address field.
3 Click the Save Settings button.
To disable MAC address cloning, select the default setting, Disable . Click the Save
Settings button to save your configuration.