D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
67
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration Network [1] IEEE8021X Eap Tls
Enable or disable the use of EAP-TLS (Transport Layer Security) for IEEE802.1x connec-
tions. The EAP-TLS protocol, defined in RFC 5216, is considered one of the most secure EAP
standards. LAN clients are authenticated using client certificates.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network
n
IEEE8021X Eap Tls:
Tls
where
n
: Index that identifies the network. Range: 1..1
Tls
: Off/On
Off: The EAP-TLS protocol is disabled.
On: The EAP-TLS protocol is enabled (default).
xConfiguration Network [1] IEEE8021X Eap Peap
Define the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN
clients without the need for client certificates. Developed by Microsoft, Cisco and RSA Security.
Requires user role: ADMIN, USER
Default value: On
USAGE:
xConfiguration Network
n
IEEE8021X Eap Peap:
Peap
where
n
: Index that identifies the network. Range: 1..1
Peap
: Off/On
Off: The EAP-PEAP protocol is disabled.
On: The EAP-PEAP protocol is enabled (default).
xConfiguration Network [1] IPStack
Select if the system should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE:
After changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role: ADMIN, USER
Default value: Dual
USAGE:
xConfiguration Network
n
IPStack:
IPStack
where
n
: Index that identifies the network. Range: 1..1
IPStack
: Dual/IPv4/IPv6
Dual: When set to Dual, the network interface can operate on both IP versions at the
same time, and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the system will use IPv4 on the network interface.
IPv6: When set to IPv6, the system will use IPv6 on the network interface.
xConfiguration Network [1] IPv4 Assignment
Define how the system will obtain its IPv4 address, subnet mask and gateway address. This
setting applies only to systems on IPv4 networks.
Requires user role: ADMIN, USER
Default value: DHCP
USAGE:
xConfiguration Network
n
IPv4 Assignment:
Assignment
where
n
: Index that identifies the network. Range: 1..1
Assignment
: Static/DHCP
Static: The addresses must be configured manually using the Network IPv4 Address,
Network IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfiguration
