D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
114
Cisco TelePresence MX700 and MX800
API Reference Guide
xCommand Audio Sound Play
Play a specified audio sound.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Audio Sound Play [Loop:
Loop
] Sound:
Sound
where
Loop:
Off/On
Determines whether or not to loop the playout of the audio sound. The sound is
looped by default. Irrespective of how this parameter is set, some of the sounds
(Busy, CallWaiting, Dial, Ringing, and SpecialInfo) will play until the Audio Sound Stop
command is issued. The default is set to Off.
Sound:
Alert/Bump/Busy/CallDisconnect/CallInitiate/CallWaiting/Dial/KeyInput/KeyInputDelete/
KeyTone/Nav/NavBack/Notification/OK/Pairing/PresentationConnect/Ringing/SignIn/SpecialInfo/
TelephoneCall/VideoCall/VolumeAdjust/WakeUp
Choose which ringtone to play.
xCommand Audio Sound Stop
Stop playing audio sound.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Audio Sound Stop
xCommand Audio SpeakerCheck
Runs a test that you can use to check that all the internal speakers are connected correctly. A
test tone will be emitted from each speaker in sequence, from left to right. If the speakers don't
play in correct order, reconnect the loudspeaker cables to obtain the correct sequence. All
speakers are part of the test sequence, and you must be in the same room as the video system
to verify that the test sequence plays correctly.
The video system uses the connected microphones to listen for the test signal, and the result of
the test is returned in the API.
Requires user role: ADMIN, USER
USAGE:
xCommand Audio SpeakerCheck [MeasurementLength:
MeasurementLength
] [Volume:
Volume
]
where
MeasurementLength:
Integer (1..5)
Test signal duration for each speaker in seconds. The default is 1 second.
Volume:
Integer (1..30)
Test signal level. The default value is 1.
xCommand Audio SoundsAndAlerts Ringtone List
List all available ringtones. Use the xConfiguration Audio SoundsAndAlerts RingTone setting to
choose a ringtone.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Audio SoundsAndAlerts Ringtone List
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand
