C H A P T E R
4-1
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
OL-19695-01
4
First-Time Setup
Revised: January 25, 2010, OL-19695-01
This chapter describes the steps you take to configure the CTS 1100 to use it for the first time and
includes the following sections:
•
•
Required Tools and Accessories, page 4-2
•
•
Loading your Software and Initial System Configuration, page 4-4
•
Configuring an Alternate TFTP Server (Optional), page 4-11
•
Setting Up the Display, page 4-11
•
Setting Up the Camera, page 4-13
•
Setting Up the Speakers, page 4-27
•
Setting Up the Microphone, page 4-28
•
Verifying Proper Function of the Lights, page 4-29
Summary Steps
To set up the CTS 1100 to use it for the first time, complete the following procedures:
Step 1
Make sure that your administration has loaded the correct version of Cisco Unified Communications
Manager software. For more information, refer to the
Cisco Unified Communications Manager
Installation Guide for Cisco TelePresence System
for your software release.
Step 2
Load the CTS Administration Software by completing the procedure in the
Cisco TelePresence System Administration Software” section on page 4-4
Note
The CTS 1100 requires a minimum CTS Administration Software version of 1.5.10.
Step 3
Set up the display by completing the procedure in the
“Setting Up the Display” section on page 4-11
Step 4
Set up the camera by completing the procedure in the
“Setting Up the Camera” section on page 4-13
.
