4-15
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
OL-19695-01
Chapter 4 First-Time Setup
Setting Up the Camera
Step 2
Place the small spirit level on top of the camera. If the camera is not level, adjust the camera using the
camera rotation screws until the camera is level.
Figure 4-8
Leveling the Camera Assembly
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target, complete the following steps.
Step 1
Remove the easel, large camera target, and small camera target from their packaging.
Step 2
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 3
Separate the three legs.
Step 4
Raise the front legs until they are 29 inches (74 cm) high.
Step 5
Raise the rear leg until it is 31 inches (79 cm) high.
Step 6
Lock the legs into place using the leg locks.
Step 7
Attach the large camera target to the clip on top of the easel.
Step 8
Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9
Raise and lower the front legs until the bottom of the camera target is 32 inches (81 cm) above the
ground.
Level
C
a
mer
a
rot
a
tion
screw
C
a
mer
a
rot
a
tion
screw
206626
