Cisco Aironet 340 Series, Hardware Installation Manual

Page: 68 / 132

Chapter 3 Installing the Client Adapter
Installing the Client Utilities and Enabling LEAP or EAP
3-30
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
OL-0795-01
Installing the Client Utilities and Enabling
LEAP or EAP
Note This section provides instructions for installing the client utilities
and enabling LEAP or EAP for Windows 95, 98, NT, 2000, and Me.
If your computer is using a Windows CE, Linux, or Macintosh
operating system, the client utilities are installed with the driver (see
the “Installing the Correct Driver” section on page 3-6), and LEAP
is enabled through the client utilities (refer to the Cisco Aironet
Wireless LAN Adapters Software Configuration Guide for
instructions).
After you have installed the appropriate driver for your computer’s operating
system, you can install the Aironet Client Utility (ACU), Link Status Meter
(LSM), and Client Encryption Manager (CEM) utilities. ACU allows you to
configure the client adapter, enable server-based authentication, and enable the
Wired Encryption Privacy (WEP) feature; LSM provides troubleshooting and
status information; and CEM enables you to set one or more WEP keys for your
client adapter.
Note
The following procedure assumes you are installing the client
utilities from the CD provided. If your computer does not have a
CD-ROM drive, download the utilities from Cisco’s web site at
http://www.cisco.com/public/sw-center/sw-wireless.shtml. Under
“Wireless Software Products - Cisco Aironet Drivers and Utilities,”
select your computer’s operating system and the appropriate utility.