Cisco Aironet 340 Series, Hardware Installation Manual

Page: 63 / 132

3-25
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
OL-0795-01
Chapter 3 Installing the Client Adapter
Installing the Correct Driver
Step 6
Version 3.1.21 of Card and Socket Services is provided on the Cisco Aironet
Series Wireless LAN Adapters CD. If you want this version to be unpacked into
the current directory (or into the /tmp directory if the current directory is read
only), type y and press Enter, and go to Step 8.
Note
If you want to use a different version of Card and Socket
Services, you can break away from this installation to obtain
a different version from the Internet (at the address
specified) and then continue the installation.
Step 7 When you are asked if you have already installed Card and Socket Services,
perform one of the following:
•
If you have not installed Card and Socket Services, type n, press Enter, and
go to Step 8.
• If you have already installed Card and Socket Services, type y, press Enter,
go to the directory where the file is installed, and type make -f airo_cs.mk
install. Go to Step 12.
Step 8
Type make config and press Enter.
Step 9
When you are prompted to respond to a series of questions, press Enter to accept
the default value for each question.
Note The default responses for each question are correct for most
users. Consult the PCMCIA-HOWTO for additional
information about each option.
Step 10
After you have responded to each question, type make all and press Enter.
Step 11
After the make all command is finished executing, type make install and press
Enter.
Step 12
Perform one of the following:
•
If you do not want to limit access to the client utilities to root users (those
with administrative rights), no action is required. Proceed to Step 13.
• If you want only root users to be able to run the client utilities and configure
the client adapter, type chmod 500 /path/acu (where path is the exact path to
where the utilities were installed in Step 4), press Enter, type chmod 500
/path/cem, and press Enter.