A-73
Catalyst 6500 Series Switches Installation Guide
OL-5781-08
Appendix A Power Supply Specifications
Power Supply Redundancy
Figure A-48
WS-CAC-4000W-INT= (International)
Figure A-49
WS-CAC-4000W-US= (United States)
Power Supply Redundancy
Catalyst 6500 series switching modules have different power requirements. Depending upon the wattage
of the power supply, certain switch configurations might require more power than a single power supply
can provide. Although the power management feature allows you to supply power to all installed
modules with two power supplies, redundancy is not supported in this configuration. Redundant and
combined power configurations are summarized in
Table A-42
. The effects of changing the power
supply configurations are summarized in
Table A-43
.
Note
For proper load-sharing operation in a redundant power supply configuration, you must install two
modules in the chassis. If you fail to install two modules, you might receive spurious OUTPUT FAIL
indications on the power supply.
Note
In systems that have two different sized power supplies installed, you may not have true redundancy. If
the larger wattage power supply fails, the smaller wattage power supply might not be able to handle the
entire load by itself.
Cordset rating: 32 A, 250 V
Length: 12 ft 0 in. (3.65 m)
Plug: IEC 60309
113365
Hardwired to
power
supply
Cord
s
et r
a
ting:
3
0 A, 250 V
Length: 12 ft 0 in. (
3
.65 m)
H
a
rdwired to
power
su
pply
Pl
u
g: NEMA L6-
3
0
11
33
66
