4-2
Catalyst 6500 Series Switches Installation Guide
OL-5781-08
Chapter 4 Removal and Replacement Procedures
Removing and Installing the AC-Input Power Supplies
The switch can bring up only an identical replacement module online. To support OIR of an identical
module, the module configuration is not removed from the running-config file when you remove a
module.
If the replacement module is different from the removed module, you must configure it before the switch
can bring it online.
Layer 2MAC addresses are stored in an EEPROM, which allows modules to be replaced online without
requiring the system to update switching tables and data structures. Regardless of the types of modules
installed, the Layer 2 MAC addresses do not change unless you replace the supervisor engine. If you do
replace the supervisor engine, the Layer 2 addresses of
all
ports change to those specified in the address
allocator on the new supervisor engine.
For instructions on installing and replacing modules, refer to the
Catalyst 6500 Series Ethernet Modules
Installation Guide
.
Removing and Installing the AC-Input Power Supplies
This section describes how to remove and install AC power supplies in the Catalyst 6500 series chassis.
The AC-input power supplies have three different form factors, which are not interchangeable between
the Catalyst 6500 series chassis.
Table 4-1
lists the AC-input power supplies, the chassis that they are
supported on, and the corresponding removal and replacement procedures.
Table 4-1
Catalyst 6500 Series AC-Input Power Supplies Removal and Installation Procedures
Power Supply
Chassis Supported
Removal and Installation Procedure
950 W (PWR-950-AC)
1400 W (PWR-1400-AC)
Catalyst 6503
Catalyst 6503-E
“Removing and Installing the 950 W and
1400 W AC-Input Power Supplies” section on
page 4-3
2700 W (PWR-2700W-AC)
Catalyst 6504-E
“Removing and Installing the 2700 W
AC-Input Power Supply” section on page 4-6
1000 W (WS-CAC-1000W)
1300 W (WS-CAC-1300W)
Catalyst 6506
Catalyst 6509
Catalyst 6509-NEB
“Removing and Installing the 1000 W,
1300 W, 2500 W, 3000 W, 4000 W, 6000 W,
and 8700 W AC-Input Power Supplies” section
on page 4-9
2500 W (WS-CAC-2500W)
3000 W (WS-CAC-3000W)
4000 W (WS-CAC-4000W)
6000 W (WS-CAC-6000W)
8700 W
1
(WS-CAC-8700W-E)
1.
While the 8700 W power supply can be installed in any Catalyst 6500 series chassis with the exception of the 3-slot and the 4-slot chassis, the power
supply’s form-factor is slightly different from the other power supplies listed. The form-factor difference requires you to move the system ground from
the chassis ground pad on the Catalyst 6506, Catalyst 6509, or Catalyst 6509-NEB chassis to the power supply system ground lugs.
Catalyst 6506
Catalyst 6506-E
Catalyst 6509
Catalyst 6509-E
Catalyst 6509-NEB
Catalyst 6509-NEB-A
Catalyst 6509-V-E
Catalyst 6513
Catalyst 6513-E
2
2.
The 2500 W AC-input power supply is not supported on the Catalyst 6513-E switch chassis.
“Removing and Installing the 1000 W,
1300 W, 2500 W, 3000 W, 4000 W, 6000 W,
and 8700 W AC-Input Power Supplies” section
on page 4-9
