3-2
Catalyst 6500 Series Switches Installation Guide
OL-5781-08
Chapter 3 Installing the Switch
The chapter contains the following sections:
•
Rack-Mounting Guidelines, page 3-3
•
Unpacking the Switch, page 3-5
•
Chassis Installation Kits and Cable Guides, page 3-5
•
Installing a Catalyst 6503 or Catalyst 6503-E Switch Chassis, page 3-8
•
Installing a Catalyst 6504-E Switch Chassis, page 3-12
•
Installing a Catalyst 6506 or Catalyst 6506-E Switch Chassis, page 3-17
•
Installing a Catalyst 6509 or Catalyst 6509-E Switch Chassis, page 3-21
•
Installing a Catalyst 6509-NEB or Catalyst 6509-NEB-A Switch Chassis, page 3-26
•
Installing a Catalyst 6509-V-E Switch Chassis, page 3-36
•
Installing a Catalyst 6513 or Catalyst 6513-E Switch Chassis, page 3-42
•
Generic Installation Procedures, page 3-47
•
Establishing the System Ground, page 3-52
•
Installing the Power Supplies in the Switch Chassis, page 3-61
•
Attaching the Interface Cables, page 3-61
•
Verifying Switch Chassis Installation, page 3-84
Warning
Class 1 laser product.
Statement 1008
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both.
Statement 1043
