Chapter 3 Installing the Router
Using Flash Memory Cards in the RP
3-78
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
To copy a configuration file named
myfile2
from the NVRAM on the RP to a Flash
memory card in slot 0, follow these steps:
Step 1
Enter the
show bootvar
command at the privileged EXEC mode prompt to
display the current setting for the CONFIG_FILE environmental variable, as
follows:
Router#
show bootvar
.
.
.
CONFIG_FILE variable =
Current CONFIG_FILE variable =
.
.
.
Router#
The absence of any notation following the CONFIG_FILE variable statement in
this sample display indicates that the environmental variable points to NVRAM
(the system default).
Step 2
To begin the copy operation, enter a
copy
command in the following form at the
privileged EXEC mode prompt:
copy startup-config
[
slot0
:
|
slot1:
]
filename
where
startup-config
Specifies the source of the file to be copied (NVRAM).
[
slot0:
|
slot1:
]
filename
Specifies the destination of the file (the Flash memory
card slot number) and the name of the new file.
