3-61
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Chapter 3 Installing the Router
Configuration Changes
Note
You might have to establish additional configuration parameters for the installed
ATM line cards if you want to use all their capabilities. For example, additional
steps are required to configure permanent virtual circuits (PVCs).
After you have manually configured the network interface parameters using the
setup
command utility or the
setup
command, your RP and line card interfaces
are available for limited use. To modify the currently saved configuration
information, enter the
setup
command at the privileged EXEC mode prompt
(
Router#
) at any time to start another System Configuration Dialog session.
To perform more complex configuration tasks, enter the
configure terminal
command at the privileged EXEC mode prompt (
Router#
) to invoke the global
configuration mode [
Router(config)#
].
Checking the Software Version
To determine the current version of the Cisco IOS software running on your
router, enter the
show version
command at the user EXEC prompt. The Cisco IOS
software version number is displayed, as well as other information, including the
hardware installed in the system, the names and sources of system image files, and
the contents of the software configuration register. The
show version
command
also identifies the type of router.
The example in the
show version Command
section that follows below shows
typical results from the
show version
command. Depending on the image version
of the Cisco IOS software running on your router and the way it is equipped, the
results of your
show version
command might be different.
show version Command
Router#
show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-M)
12.0(20020120:204554)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 20-Aug-01 18:34
Image text-base: 0x60010950, data-base: 0x61C00000
ROM: System Bootstrap, Version 11.2(17)GS2, [name 180] EARLY
DEPLOYMENT RELEA)
