Chapter 3 Installing the Router
Installing a Router
3-6
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
OL-11497-03
Tools and Equipment Required
You need the following items to install the optional center-mount rack-mounting
brackets:
•
Number 2 Phillips screwdriver
•
Tape measure (optional)
•
Level (optional)
Installing the Optional Center-Mount Brackets
To install the center-mount brackets, see
Figure 3-2
and follow these steps:
Step 1
Measure and mark the hole at the same height on both the left and right posts.
Caution
When installing the right side lower center-mount bracket, ensure that the bracket
does not impede airflow through the air filter, which could cause overheating in
the router.
Step 2
Mount the lower right bracket:
a.
Hold the lower right bracket against the right rack rail and align the bottom
screw hole in the lower bracket with the marked screw hole.
b.
Pick a bottom bracket hole that aligns with a hole in the rack rail, then insert
a screw in the hole and finger tighten the screw.
c.
Insert a second screw in the top hole in the bracket and finger tighten that
screw.
Step 3
Repeat Step 2
a
through Step 2
c
to mount the lower left center-mount bracket so
that it is at the same height as the lower right bracket.
Step 4
Use a level to verify that the tops of the two brackets are level, or use a measuring
tape to verify that both brackets are the same distance from the tops of both rack
rails.
Step 5
Use a screwdriver to tighten all the screws.
Step 6
Repeat Step 1 through Step 5 for both upper center-mount brackets.
