Rev Z
Page 46
11/28/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be reproduced without the express
written permission of Cirus Controls LLC for each reproduction.
Granular Material Flow Sensing:
when installed, the granular sensor is monitored by
SpreadSmart
TM
and warns the operator when material is
not
moving past the sensor.
Pressure Sensor Display:
when installed with the optional Large Format display, the
SpreadSmart
TM
system displays a hydraulic pressure reading from a pressure sensor installed in
the hydraulic system.
Installation:
the MDM is designed to be installed in the cab of the truck in close proximity to
the
SpreadSmart
TM
CPU.
1) Connect all cables:
DC 1000 - Multi-plex input cable; connect to MDM 400 module;
a) Hopper sensor
mplex connector 1;
b) Gate Height sensor
mplex connector 2;
c) Material Flow sensor
mplex connector 3;
d) Hydraulic pressure sensor
mplex connector 4;
DC 1001 and DC 1002 – sensor input cables. Choose for proper connection to sensors in use.
Plug into DC-1000 cable as shown above.
HH1001 -Cirus Bus Cable; connect to Bus port on MDM 400 and on
SpreadSmart
TM
CPU.
MK 1003 – Power cable, connect to 12v supply, ignition hot and battery ground;
Configuration
: Turn on
SpreadSmart
TM
and enter the configuration menu as before.
Select Trim/Cal and select MDM Module:
Enable Sensors installed in the truck using “anti-ice +/-” key to choose yes or no.
a)
Calibrate the Gate Height Sensor
Default Gate Height setting
: choose this opening size and always use this opening size for
material calibration steps. Use “anti-ice +/-” key to raise or lower this value (allowable range is
1.5 to 24 inches). Select “default gate height setting” and hit “pass.”
