Rev Z
Page 37
11/28/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be reproduced without the express
written permission of Cirus Controls LLC for each reproduction.
5)
Spinner Stops with Truck: answer yes to allow the spinner to keep spinning very slowly
while the truck is stopped in order to keep the hydraulic fluid moving and warm. The
auger is stopped when truck motion is stopped. Choose “no” to stop spinner when truck
is stopped.
6)
Press the spinner control until the one lane speed setting is selected.
Note this step is usually done without material in the truck, for the purpose
of estimating final spinner trim settings and to allow the truck to enter “un-
calibrated automatic mode”.
Set the Trim for the Rotational Speed of the “One Lane Setting” (minimum trim):
Enter the configuration menu and select trim/cal as before. Select spinner trim.
1)
Select the “one-lane wide” trims setting and follow the on screen instructions.
2)
Increase the auger setting until a “normal” auger speed is occurring.
3)
Increase the spinner setting until a “one-lane wide” spinner speed is occurring
(note: this rotational speed is your estimate based on observation of the spinner
speed. Accurate calibration will be done later)
4)
Press pass to accept the “one lane” speed setting.
Set the Trim for the Rotational Speed of the “Three Lane” Setting (maximum trim):
5)
Select the “three-lane wide trims” setting and follow the on screen instructions.
6)
Increase the auger setting until a “normal” auger speed is occurring.
7)
Increase the spinner setting until a three-lane wide spinner speed is occurring
(note: this rotational speed is your estimate and must be faster than the setting you
chose in the one-lane wide step. Accurate calibration will be done later).
8)
Press pass to accept the “three lane” speed setting.
Note
: at this stage, the trims for 1 and 3 –lane blast settings are the same as those chosen here.
Final settings for Blast will be completed during the calibration step.
Zero velocity spinner configuration
Enter the configuration menu and select trim/cal as before. Select spinner trim.
1.
Spinner Present: Set to yes if spinner present.
2.
Sensor Present: set to yes for Zero velocity spinner;
WARNING
Potential for injury due to unexpected
operation of spinner.
Granular material thrown off the spin-
ner will cause severe eye injury, with
possible permanent loss of vi sion.
Contact with a moving spinner will
cause injury to extremities and other
body parts.
During initial startup and te sting, the
spinner may start without warning.
Stay clear of the spinner during all
startup, programming, and operation
procedure s.
Do not attempt to clear a jammed spin-
ner with the hydraulic or control sys-
tem active.
