Rev Z
Page 36
11/28/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be reproduced without the express
written permission of Cirus Controls LLC for each reproduction.
observe the auger motion. The spinner control is functional during auger trim calibration to
prevent material piling up on the spinner.
1)
Raise the hydraulic level (auger button) until the auger is barely moving.
2)
Press pass to accept this speed as the minimum trim level.
3)
Increase the hydraulic level until maximum auger speed is achieved.
4)
Press pass again to accept the maximum trim levels.
5)
Once the maximum trim level is accepted, the user is asked to “accept calibration”.
Select “Y” using the spinner control, and then press pass.
6)
The auger trim is now set, select blast to return to the main menu.
(Note: Do not adjust the factory settings for “pulses per pound.” They will be changed during
the material drop test).
Automatic Auger / Conveyor Trimming
If you selected automatic trim calibration, the unit automatically selects the trim levels
using the sensor as feedback.
The spinner control is functional during auger trim calibration,
to prevent material piling.
1)
Step through the on screen instructions using the pass button to begin trim calibration.
2)
Once initiating auto trimming, you have 10 seconds to raise the engine RPM.
3)
Hold RPM constant while unit is calibrating. This may take as much as two minutes.
(You may cancel the trim test at any time using the blast key.)
4)
Once the automatic trim calibration test is completed, the user is asked to “accept
calibration”. Select “Y” using the spinner control, and then press pass.
Spinner and Zero velocity Set Up and Baseline Trimming
Standard Spinner Configuration and Trimming
Enter the configuration menu and select trim/cal as before. Select spinner trim.
1)
Spinner Present: Set to yes if spinner present.
2)
Sensor Present: Default is “no” because most systems do not have a spinner sensor, and
systems with a spinner sensor require a special pigtail.
3)
Zero velocity: if your spinner is a zero velocity type, answer yes. If not, answer no. If
you answer yes, the screen will change to “zero velocity set-up.”
4)
Show Spinner in %: answer yes to show spinner in % output instead lanes.
WARNING
Potential for injury due to unexpected
operation of auger.
Entanglement in the auger will cause
severe injury to extremities, with pos-
sible loss of extremities.
During initial startup and te sting, the
auger may start without warning. Stay
clear of the auger during all startup,
programming, and operation proce-
dures.
Do not attempt to clear a jammed au-
ger with the hydraulic or control sys-
tem active.
