The
key skips to the previous digit and the
key skips to the next digit.
Press
to validate the data; the
symbol disappears from the display.
Lo
Value
and
HI
Value:
Maximum value:
99 %
Minimum value:
1 %
If the value entered is lower than the minimum value or higher than the maximum value, the backlight
of the display flashes and the value entered is replaced with the minimum or maximum value, or with
the last value validated.
Press the
key to access the next programming step.
If no keys are pressed for 5 minutes, the unit switches to the simulation screen,
.
5�26�- CURRENT x I THD ALARM
In this point the thresholds above which the alarm for the percentage of the value of the current x
ITHD (
E09
) is activated can be configured. The programmed values are useful for the 3 phases which
the unit measures.
Note:
The alarm must be enabled
(
).
Press the
key to enter editing mode. It is identified by the
symbol and the blinking of the
digits to be modified.
The value to be programmed in this alarm corresponds directly to the value of the total harmonic
current to be considered as the setpoint.
For example:
If you want to program a
Lo
setpoint value
when exceeding a harmonic current of 200 A measured by the regulator, program
00200
directly in
this section.
The parameters to be configured are:
98
Computer SMART III FAST
Instruction Manual
Summary of Contents for Computer SMART III FAST 12
