Circutor Computer SMART III FAST 12, Instruction Manual

Page: 9 / 112

3.- DEVICE INSTALLATION
3�1�- PRELIMINARY RECOMMENDATIONS
In order to use the unit safely, it is critical that individuals who handle it follow the safety
measures set out in the standards of the country where it is being used, use the person-
al protective equipment necessary, and pay attention to the various warnings indicated
in this instruction manual.
The
Computer SMART III FAST
unit must be installed by authorised and qualified staff.
The power supply plug must be disconnected and measuring systems switched off before handling,
altering the connections or replacing the unit. It is dangerous to handle the unit while it is powered.
Also, it is critical to keep the cables in perfect condition in order to avoid accidents, personal injury and
damage to installations.
The manufacturer of the unit is not responsible for any damage resulting from failure by the user or
installer to heed the warnings and/or recommendations that appear in this manual, nor for damage
resulting from the use of products or accessories that did not come with the unit or that were made
by other manufacturers.
If an anomaly or malfunction is detected in the unit, do not use the unit to take any measurements.
Inspect the work area before taking any measurements. Do not take measurements in dangerous ar-
eas or where there is a risk of explosion.
Disconnect the unit from the power supply (unit and measuring system power supply)
before maintaining, repairing or handling the unit's connections.
Please contact the after-sales service if you suspect that there is an operational fault
in the unit.
3�2�- INSTALLATION
The Computer SMART III FAST regulator is connected to units that contain capacitors,
which remain charged after the voltage source is disconnected.
Wait at least 5 min-
utes after the unit is disconnected before handling its internal components in order to
avoid the risk of electric shock.
Any manipulation or use of the unit other than that specified by the manufacturer
may compromise user safety�
Make sure that the units are correctly earthed before they are connected. A faulty earth connection
could lead to faulty operation and lead to a risk of electrical shock for the user or person handling the
unit.
Resonance can occur when the unit is connected with no load. In this case, the voltage harmonics can
be amplified, causing damage to the compensation unit and other units connected to the mains.
9
Instruction Manual
Computer SMART III FAST