CIAT AirCompact Control, Control Manual

Page: 43 / 69

43
• select the desired value using the
 
buttons and confirm by pressing the

button. If the value selected is different from that
previously stored in memory, the mask of the screen below will appear and the new value will be stored in the display's permanent
memory.
If the nn field is set to '0', the terminal will use the Point-to-Point Protocol (not the pLAN) to communicate with the controller and the
“I/O Board address: 07” field will disappear as it will not be necessary.
3.3.2
Assigning private and shared terminals
Follow the procedure below if, at this point, it is necessary to change the list of terminals associated with each controller:
• enter configuration mode by pressing the
 
and

buttons as described in the previous section;
• press enter until the pointer moves to the "I/O board address" field;
• using the
 
buttons, select the address of the desired controller. The only values selectable will be those of the controllers that
are on the network. If the pLAN network is not working correctly or if no controllers are present, the field cannot be changed and
will display a “—”;
• press the
enter button once more. the following mask sequences will be displayed:

• as above, press
enter to move the pointer from field to field. Press the
 
buttons to change the value of the current field. The
P:xx field shows the address of the selected controller. In the example above, controller No. 07 is selected;
• to exit the configuration procedure and store the data, select "YES" in response to “OK?” and confirm with the

button.
In the case of a shared display for a set of units (maximum 31), the terminal must be configured on each unit in "Sh" mode.
The fields in the “Adr” column contain the addresses of the terminals associated with the controller whose address is 07; the
“Priv/Shared” column shows the terminal type.
Warning: HMI terminals do not have a printer output and therefore cannot be configured as “Sp” (shared printer).
If the terminal remains inactive (no buttons pressed) for more than 30 seconds, it will automatically exit configuration mode without
saving any changes made.