Section 6: Specifications
Matrix StIM/SIM Setup Guide
6-7
020-100397-02 Rev. 1 (11-2012)
NOTES: 1)
Value specifies frame rate of non-interlaced sources and field rate for interlaced sources. Frame/
field rates higher than the maximum refresh rate of the panels will be displayed at a lower rate
.
2)
Does not
apply to sync-on-green/luma.
3)
As the horizontal frequency increases and/or as the vertical scaling ratio of
input lines to output lines increases many sources will run into the internal 180Mpix/s processing which limits
the number of pixels that can be processed.
SYNC
(Interlaced or Progressive Scan Format)
Horizontal Frequency Range
15 – 150Hz
Vertical Frequency Range 1,3
23 – 150Hz
Sync Type
Separate H and V
Composite (bi-level, tri-level, XOR)
Sync-On-Green/luma (bi-level, tri-level)
Serrations and/or Equalization pulses
MarcoVision compatible
Polarity 2
Positive or Negative
Input Levels 2
0.5Vpp – 4.0Vpp
DC Operating Range 2
±3V
Nominal Impedance 2
75 ohms
Horizontal Sync Duty Cycle
3% min, 20% max
DVI-I – ANALOG
Input Characteristics
Same as Analog RGB, except as noted below.
Formats
RGB or YPbPr – video signal cannot be routed to the decoder
Sync Types
Separate H and V (direct or swapped)
Bi-level – TTL levels only
Composite (XOR, OR)
Sync-on-green
Serrations and/or Equalization pulses
MacroVision (standard & progressive)
Analog Sync Logic Low
0V – 0.8v
Analog Sync Logic High
2.4V – 5V
Analog Sync Input Impedance
1kW
Summary of Contents for Matrix SIM
