Christie Matrix SIM, Setup Manual

Page: 38 / 60

4-2 Matrix StIM/SIM Setup Guide
020-100397-02 Rev. 1 (11-2012)
Section 4: Basic Operation
Auto
Initiates an automated process in which the projector optimizes critical display parameters such as size,
position, pixel tracking, etc., for the current source. These parameters are listed in the following table. An auto
setup can save time in perfecting a display, before you make adjustments as required.
NOTE:
You must have an
unlocked channel present to use Auto Setup.
The best auto setup will be obtained under the following conditions:
• Input levels: It is best to have an image with saturated (very bright) colors.
• Phase: High contrast edges are needed.
To determine active window size:
• Video images should have whites and blacks in the image.
• Wide range video images should have content (including white) that extends to all edges of the image.
Channel
Select a specific source setup (channel) defined and stored in projector memory. To select a channel, press
C
HANNEL
and enter a 2-digit channel number; or, if there is a list displayed, highlight it and press
E
NTER
. The
display will automatically change and update according to the numerous setup parameters defined for that
channel.
NOTE:
A new channel is automatically created if you adjust an image from a new source. Channel
key behavior during a presentation depends on whether or not the Display Channel List option is enabled in
the Menu Preferences menu. You can choose to use a scrollable list of channels when you press Channel, or
you can enter the channel number without on-screen feedback.
Slot 1, 2, 3, 4
Press a
S
LOT
key to select the input card in that slot. Press the
S
LOT
key again to display the next active Input
on the card. Press a different
S
LOT
key to select a different input card.
Input
Displays all inputs in all slots, both active and inactive. Press
I
NPUT
once and scroll through the list to select an
input for the main image. Press
I
NPUT
again and select the secondary image.
PIP
Switches the secondary image (picture-in-picture or picture-by-picture) ON or OFF.
Swap
Swaps between the main and secondary images.
OPTIMIZES SETS TO DEFAULT
Pixel Tracking Contrast
Pixel Phase Brightness
Size and Blanking Auto Input Level (OFF)
Vertical Stretch Detail (if video source)
Position Filter
Input Levels Luma Delay