Christie Matrix SIM, Setup Manual

Page: 49 / 60

Section 5: Troubleshooting
Matrix StIM/SIM Setup Guide 5-7
020-100397-02 Rev. 1 (11-2012)
5.6 ArrayLOC
5.6.1 Cannot Find Color Adjustment Controls
Use the color adjustment options under the ArrayLOC menu: access Main menu > Configuration >
ArrayLOC . Color Adjustments by X,Y and Color Saturation options are not available for general use. They
are part of the passcode protected Service menu.
5.6.2 Color/Image Settings Are Grayed Out
To enable ArrayLOC: access Main menu > Configuration > ArrayLOC > Bright/ColorLOC Mode and set
to Fixed, Cool, or Bright .
If ArrayLOC is enabled
• ArrayLOC handles brightness and color settings, and overrides other color settings, for example Advanced
Image Settings > Color Settings .
• Main menu > Configuration > ArrayLOC > Array Color Target color settings are available for the
master projector and are grayed out for all other projectors. To make your projector the master: access Main
menu > Configuration > ArrayLOC > Synchronize to This Projector . Any projector in the array or BC
group can be the master. The last projector to be set as the master is the master for the array (All) or BC
group (Group). This setting is not saved between session.
5.6.3 Sensor Is Not Calibrated (yellow alert)
Sensor calibration must be performed by Christie accredited service technicians. Contact customer support.
5.6.4 Invalid Target Gamut (yellow alert)
A color setting is not valid for the current color space, for example a white point is outside of the gamut.
1. Access the Array Color Target menu: Main > Configuration > ArrayLOC > Array Color Target .
2. Check XY settings for the colors.
5.6.5 Unable to Achieve Target Brightness and Gamut (yellow alert)
A projector in an array that cannot achieve minimum brightness or target color space will disable BCLOC and
cease contributing data to performance calculations.
• Try lowering the target brightness or target color gamut settings until all the projectors can achieve the same
performance.
• If the discrepancy is too big, the light module may need to be replaced. Contact customer support.