Chopin AlveoPC, Maintenance Manual

Page: 128 / 174

128
Maintenance manual
2016/02
AlveoPC
6. If the mixing blade makes contact, remove it and realign the
gear motor with the bowl using the spacers until it no longer
scrapes.
7. Once adjusted, rotate the gear motor slowly, leaving the mix-
ing blade in place to check that it rotates smoothly without fric-
tion.
Note: If these adjustments are inconclusive, the gear motor is prob-
ably incorrectly positioned: in which case loosen and align it
(see op. Operation B3-1) .
8. Fully tighten the bowl's screws.
9. Remove the special tool. Replace the ball support (G).
10. Connect all the electrical connections on the new bowl assem-
bly on the Mixer board and on the solenoid valve.
11. Put the hydraulic couplers back on the bowl and reconnect the
hoses, respecting the initial routing (H).
Note: We recommend changing the hoses.
12. Put the casing back on (see op. Operation B1-1) .
13. Run a no-load test to ensure there are no suspicious noises.
B4: Mixer bowl
Operation B4-1 Removing/replacing bowl assembly
Page: 3/3
Consumables:
Tools:
-
Motor drive “crank”
G
H