Chopin AlveoPC, Maintenance Manual

Page: 140 / 174

140
Maintenance manual
2016/02
AlveoPC
1. Remove the casing (see op. Operation B1-1) , and turn it
upside down.
2. Remove the screws from the exposed conductive part of the
keyboard on the Mixer casing (A).
3. Note the orientation of the keyboard connection on the bridge
board, then disconnect the latter (B).
There is no connection fool-proofing device on it! (the cable
loops without twisting).
4. Unstick the keyboard from the Mixer casing and discard it.
5. Carefully clean the keyboard location with solvent.
Please note: the keyboard must be stuck on in one go, without
attempting to unstick it, because doing so will damage it irre-
mediably.
6. Remove the adhesive protection.
7. Insert the keyboard connecting ribbon cable through the cas-
ing opening, tilt the keyboard to align its upper edge and left
edge in its frame then stick it.
8. Stick the new keyboard in its place.
9. Fix the ground wire and log in the keyboard to the bridge board
(B).
10. Put the hood back on the Mixer.
B11: Keyboard
Operation B11-1 Replacing the keyboard
Page: 1/1
Consumables:
Tools:
Solvent that does not alter the casing paintwork
-
A
B