Chevrolet 10 series 1973, Overhaul Manual

Page: 415 / 522

7 A - 1 1 2 A U T O M A T IC T R A N S M IS S IO N
Fig. 136T-Installing Direct Clutch Assembly
thrust washer on forward clutch hub. Retain with
petrolatum.
19. Install forward clutch assembly and turbine shaft;
indexing direct clutch hub so end of mainshaft will
bottom on end of forward clutch hub. When
forward clutch is seated it will be approximately
1-1/4” from pump face in case (fig. 137T).
20. Install front pump assembly and gasket.
NOTE: If turbine shaft cannot be rotated as
pump is being pulled into place, forward or
direct clutch housing have not been properly
installed to index with all clutch plates. This
condition must be corrected before pump is
pulled fully into place.
Fig. 138T-Installing Pum p Seal
FRONT END WASHER THICKNESS
Thickness
.060 - .064
.071 - .075
.082 - .086
.093 - .097
.104-.108
.115 - .119
1 .126-.130
Color
Yellow
Blue
Red
Brown
Green
Black
Purple
FRONT SEAL
Fig. 1 3 7 T -In s ta llin g Forward Clutch Assembly and
T urb in e Shaft Fig. 1 39T-C hecking Front U n it End Play
DIAL
IN D IC A T O R
J-8001
OVERHAUL MANUAL