Chevrolet 10 series 1973, Overhaul Manual

Page: 367 / 522

7 A 6 4 A U T O M A T IC T R A N S M IS S IO N
G O V E R N O R S C R E E N
A S S Y .
G O V E R N O R F EED
PIPE H O L E
Fig. 10T-A--Removing Governor Screen Assembly
Fig. llT -R e m o v in g Rear Servo Cover Attaching Bolts
5. Remove governor screen assembly from governor
feed pipe hole in the case or from end of governor
feed pipe (fig. 10T-A). Clean governor screen in
clean solvent and air dry.
6. Remove governor pipes from control valve
assembly.
7. Disconnect solenoid lead wires from connector
terminal (fig. 10T- B).
Removal of Rear Servo, Valve Body Spacer,
Gasket and Front Servo
1. Remove rear servo cover attaching screws, servo
cover and gasket. Discard gasket (fig. 11T).
1. Remove rear servo assembly from case (fig. 12T).
3. Remove rear servo accumulator spring.
S E R V O C O V E R
A T T A C H IN G B O LTS
'DETENT SO LENO ID
iWIRE
LEAD WIRE ASM
R EAR S E R V O .
A S S E M B L Y X
Fig. 12T--Removing Rear Servo Assem bly
Fig. lO T -B -D isco n n e ctin g Lead Wires from Term inal
OVERHAUL MANUAL