B-3
Installing on Existing Concrete
If installing on existing concrete, perform the following tasks:
•
Review the site for suitability to install a CPF25. The CPF25’s Clean Cord Technology requires space behind
the power stub-up for the Cord Management Kit (CMK). To ensure adequate space, reference the CPF25
Installation Template (75-001094-01) included in this installation kit.
•
Review the dimensions of the existing concrete slab. To safely mount a CPF25 charging station, the concrete
must be at least 6” thick. At this thickness, all of the CPF25’s mounting bolts must be positioned at least 15”
from the front edge, at least 12” from the side edges, and at least 6” from the rear edge of the concrete slab.
•
If an existing charging station is already in place at the installation site, turn off all power to the station and
disassemble according to the original manufacturer’s instructions. Cut away any existing bolts or non-power
conduit stub-up to ground level. You may need to plug cut-away conduits at the slab end, and disconnect
wiring at the other end.
IMPORTANT
: Always check local codes to ensure compliance. You may need to adjust these instructions to
comply with codes that apply at your installation location.
Tools Required
Electric drill or Hammer drill (
1/2
” chuck may be required depending on drill bits used)
Consumables Required
Consumable
Purpose
Epoxy Adhesive for Concrete, 9.3 Ounce Cartridge
(includes two mixing nozzles)
Filling drilled holes.
Mixing Nozzles for 9.3 Ounce Epoxy Adhesive for Concrete
Filling drilled holes.
NOTE:
You may need extra mixing nozzles to
accommodate delays of over three minutes when applying
epoxy.
Ratchet Rod Caulk Gun with Half-Barrel Frame for 10-13
Ounce Cartridge, 6:1 Thrust
Filling drilled holes.
NOTE:
Any standard caulk gun will work.
Electrical Cleaning and Maintenance Aerosol, Any Angle
Spray Duster, 8 Ounce Net Weight
Cleaning drilled holes.
Slow Spiral Round-Shank Masonry Drill Bit, 3/4” diameter,
1/2” Shank, 10” Drill Depth, 12” Length Overall
Drilling 3/4” holes in concrete.
NOTE:
The holes must be at least 6” deep.
Drill Bit for Concrete Embedded Rebar, Round, 3/4
” bit size, 1/2” Shank diameter, 12” Length Overall
Drilling 3/4” hole through rebar.
Nylon Loop-Handle Brush, 3/4” Brush Diameter, 3” Length
Brush, 8 1/2” Length Overall
Cleaning drilled holes.
Push-on Round Cap, fits 5/8” - 11/16” OD, 1/2” Inside Height,
Packs of 100
Keeping the epoxy inside the drilled holes in situations
where the slab is only 6” deep.
